GAC GA4 - Driver Assistance System; Cruise Control System

5. Driving Guide
5.3 Driver Assistance System
5.3.1 Cruise Control System *
The cruise control system can be set at
40km/h or higher. Once the speed is set, the driver
can release the accelerator pedal and the car will
run at the preset speed.
Warning
To avoid accidents, the cruise control system
cannot be used where there is dense
traffic, hills, winding roads, or slippery
roads.
• The set speed and the vehicle-to-vehicle
distance must be adapted to the current
traffic conditions. The cruise control
system is only a driver assistance system
and shall be used prudently.
• Be sure to disable the cruise control
system timely after using.
Operation Button
SET/-: Set
cruise control/ deceleration
RES/+: Restore cruise control/acceleration
: Start / stop cruise control
: Cancel cruise control
Starting Cruise Control
- Short press the button
. Then the
corresponding indicator light
on the
instrument cluster will be on and turn white.
- Accelerate the car to the cruising speed
(above 40km/h).
- Short press the SET/- button. Then the
corresponding indicator light on the instrument
cluster
will turn green from white.
- Release the accelerator pedal as the car is in
cruise control state.
242