5. Driving Guide
Whe
n the speed ex
cee
d
s
25 km/h, the tire
pressure sensor will send the data to the receiver.
After being decoded analyzed, such information will
be sent to the instrument cluster through the bus to
display current pressure and temperature.
• If the tire pressure is higher than 330Kpa, the
indicator light
of tire pressure monitoring
system will be on, and the text alarm on the
instrument cluster display screen will be
displayed as high tire pressure.
•
If the tire pressure is lower than 75% of the
normal set value, the TPMS indicator light
will be on, and the text alarm on the
instrument cluster display will be displayed as
low tire pressure.
• If the tire pressure continuously decreases
below a specified value, the TPMS indicator
light
will be on, and the text alarm on the
instrument cluster display will be displayed as
tire leakage.
• If the tire temperature exceeds 85°C, the
TPMS indicator light
will be on, and the text
alarm on the instrument cluster display will be
displayed as high tire temperature.
Caution
• Some added electronic equipment may cause
the abnormal operation of TPMS.
•
If the tire pressure sensor or the tire needs to
be replaced, or the tire position needs to be
exchanged, one should learn the matching of
sensors in four tires again. Please go to your
GAC MOTOR dealer for learning.
Hint
After replacing with a spare tire or with a new
tire in some other places, , the low tire pressure
alarm lasts during traveling because of the missing
tire sensor. Do not mistake this as abnormal tire
pressure signal.
Hint
• If the tire suffers high temperature, high
pressure, low pressure, or rapid air leakage,
the instrument cluster will give early warnin
g,
with position of the corresponding failed tire
displayed in circular manner. If the TPMS fails,
the inst
rument cluster will give early warnin
g,
with “Please check the TPMS” displayed in
circular manner.
• Where there is high temperature alarm, it is
recommended to stop the car and wait until
the tires cool.
• The traveling alarm not handled until the car
stops will remain when the car starts again,
with pressure and temperature displayed as “--
-”. But when the speed exceeds 25 km/h, the
receiver will receive updated data and update
relevant data, and then the alarm disapp
ears.
To Next Page
Loading...
