6. Usage and Maintenance
Replacin
g Fr
ont Wind
shi
eld Wiper Blade
- Switch the Start or Ignition switch
to “ON” gear,
and then to “OFF/ LOCK” gear.
- Within 10s after finishing the last step, move
the wiper combination switch to gear. By this
time, the wiper arm will move for half circle.
– Lift the wiper arm,
adjust the wiper blade as
shown and then press the wiper blade to
remove it.
-
Slowly lower the wiper arm.
- Place a new wiper blade back to the wiper arm
in reverse steps, and install after hearing a
“click”.
- Carefully lower the wiper arm back to the
windshield.
- Switch the Start or Ignition switch to “ON” gear,
making the wiper arm back to its original
position automatically.
It is recommended to replace your wiper blade
at GAC MOTOR dealer when necessary.
Caution
● When lifting the wiper arm, grasp the wiper
arm with hand, and do not grasp the soft wiper
blade.
● Be sure to use new wiper blade with the same
length and specification.
● Carefully lower the wiper arm to prevent
striking the windscreen due to instantaneo
us
drop.
●
Check the condition of the wiper blades
regularly, and replace them as required.
Timely replace the damaged wiper blade.
● Seriously worn or dirty wiper blade is very
easy to scratch the windscreen, and will
influence the forward visibility and reduce the
driving safety during use.
To Next Page
Loading...
