6. Usage and Maintenance
Procedur
e o
f
Repla
c
ing Bulbs
When replacing any bulb, do not touch the
glass with your fingers. Otherwise, the bulb heat
may evaporate your fingerprint and make it
condense on the bulb reflector, reducing the light
illumination.
Check the light operating condition after
replacement. After replacing light bulbs, go to GAC
MOTOR dealer to inspect the light beam
adjustment status of lights.
Hint
Basically the same methods will be used for
removing or installing the bulbs on the left and right
sides, so that only the removing or installing for left
side will be described herein.
Don not touch the bulb glass while removing/
installing a bulb.
Warning
Unless you have the expertise about the
operational process, safe operation
specifications and the tools, have your
GAC MOTOR dealer replace the bulb.
Replacing High Beam Light Bulb
1. Switch off the Start or Ignition switch.
2. Take out the
rubber back cover ①.
•
Turn off the relevant switch and let the bulb
cool down before replacing it.
•
During operation, pay attention to the sharp
components on the headlight housing and
the combination taillight housing in engine
compartment. Be sure to protect your
hands from being scratched.
To Next Page
Loading...
