6. Usage and Maintenance
3. Rotate counter-clo
ckwise and take out the
front turn signal holder and bulb ②.
4. Remove the front
turn signal bulb ② from the
front turn signal holder.
5.
Generally, perform the installation in the
reverse order of removal procedures
Replacing Front Position Light
The front position light and front combination
light should be seen as an entirety. Only LED bulbs
are used. It's not allowed to replace any set of
LEDs separately in repair work. If one set of LEDs
are broken, more load will be applied to the other
intact LEDs, which will significantly shorten their
service life.
In case of any failure of the front position light,
please have your vehicle checked and repaired at
GAC MOTOR dealer as soon as possible.
To Next Page
Loading...
