8. Handling of Accident
Install Rear Tow
ing Hook
– Take
out the towing hook and the wrench for
removing wheel bolts from the tool bag in the
trunk.
– Open the towing hook cover with a word knife
at the position indicated by the arrow.
– Scre
w the towing hook ① into the threaded
hole clockwise.
– Insert the wrench for removing wheel bolts ②
into the towing hook port, and rotate the
wrench clockwise to securely screw the towing
hook into the threaded hole.
– After towing, screw out the towing ring in
reverse sequence and put the bumper cover in
place.
Precautions for Traction
Before emergency traction, be sure to operate
according to the following precautions:
● The drivers of the towing and towed vehicles
must turn on the hazard warning indicator
lights, and must observe the local traffic
regulations.
● The towing hook must be securely screwed
into the threaded hole. Otherwise, the towing
hook may slip from the threaded hole during
traction process.
To Next Page
Loading...
