3. Safety Operating Instructions
– The upper anchor points ② at both sides of
the rear seats are just behind the backrests,
you may see it by opening the trim covers.
Be sure to remove/install the child safety seats
in accordance with the manufacturer's Instructions.
The installation instructions for LATCH system child
seat are mainly introduced as follows:
1. Place
the child safety seat on the seat. Find
the lower anchor point ① . Insert the lower
guide slot (see the arrows) into the lower
anchor point ① until it clicks.
2. Rai
se the headrest to the upmost position.
Pass the anchoring strap through the headrest
support and open the upper anchoring trim
cover to engage the upper anchor point ②.
Ensure that the anchoring strap is not twisted.
3. Tighten the anchoring strap, shake the child
safety seat on all sides to make sure it is
securely anchored.
4. Ensure that all unused seat belts within reach
of children are locked.
To Next Page
Loading...
