10
Starting the appliance
Note: Only use the appliance in frost-free areas. If the
appliance was transported or stored at temperatures
below 0 °C, you must wait for at least 3 hours before
using it.
The appliance must be fully installed and connected to
the mains.
Setting the language
Notes
‒ The language selection appears automatically when
first switched on after connection to a power outlet.
‒ You may change the language at any time
(see section Basic settings).
1 Switch on the appliance at the main switch.
The preset language appears in the display.
2 Turn the rotary selector to select the required
display language.
3 Confirm with ™.
The setting is saved.
Note: If the language is changed, the system restarts.
This takes a few seconds.
"Operation complete" appears in the display. Confirm
with ™. The appliance enters hibernation mode and the
hibernation mode display appears. The appliance is now
ready for operation.
Setting the water hardness
It is important to set the water hardness correctly, so
that the appliance indicates accurately when the
descaling programme should be run. The default water
hardness is level 4. If a water softener is installed in the
house, please set the water hardness to level 3. You can
check the water hardness using the enclosed test strip
or by asking your local water supplier.
1 Briefly immerse the enclosed test strip in fresh tap
water, leave it to drip off and read off the result
after 1 minute.
2 Rotate function selector to S.
3 Use the rotary selector to select "Basic settings"
and touch the ™ symbol.
4 Use the rotary selector to select "Water hardness".
5 Touch the % symbol.
6 Using the rotary selector, set the measured water
hardness.
7 Press ™ to confirm.
The setting is saved. Touch' in order to exit the basic
settings.
'HXWVFK
6SUDFKH
To Next Page
Loading...
