Gaggia Babila - Page 34

GAGGIA BABILA 05 SERVICE MODE
2/13
Activation of loads
In Test Mode all loads are initially disabled.
To activate a load press the corresponding button on keyboard, to deactivate press again the
same button.
Other conditions for which a load may be switched o automatically without key presses are:
· If it is dened a working cycle, when this cycle ends (such as the grinder or brew unit)
· The achievement of a Time-out (Example 5 minuts for boiler)
The rst two elds in the upper left indicate the version number of EEPROM MV (Memory Version)
: ww).
Pressing DOWN will switch you to the next screen. Pressing the POWER ON-OFF mode is exited
test
or you can press to exit at any page of the test mode ESC.
Commands:
· Debug: if active enables debug messages dell’autodose only for the next reboot
· D.TM: when active enables the possibility of entering the test mode of the display when you
reboot machine
· Po: if activated allows the machine to immediately enter into standby after power
from the main switch.
Following the activation of debug messages, the display will be visible the following information:
- Eort of the group at the last grinding
- Actual number of pulses that produced the eort of the brew unit
- Pulse aroma medium after correction dell’autodose following the last grinding
The eort of the brew unit and the actual number of pulses corresponding to it, are available in
the display
As soon as the brew unit moves into “work” while impulses aroma medium, correct dall’autodose,
are visible when the machine returns to “ready”.
Following the activation of debug messages, the display will be visible the following information:
- Eort of the group at the last grinding
- Actual number of pulses that produced the eort of the brew unit
- Pulse aroma medium after correction dell’autodose following the last grinding
Navigation in Test Mode
SoftwareVersion
This is the rst window of Factory Test Mode. It show the version of CPU software (xx.yy.zz.) , the
EEprom version (ww) etc.
MV :
Software xx.yy.zz
WW Debug
D. TM
PO Exit
^
^
^
^ ^ ^