Gaggia SUP-038G - Page 43

37
12 13
18
E
1110
C
D
A
B B
Place a large empty container under the
dispensing spout. Rotate the upper part of
the milk carafe directly above the container.
Place a large empty container under the
dispensing spout. Rotate the upper part of
the milk carafe directly above the container.
Upon completion of the cleaning
cycle, we recommend rinsing all the
components under fresh drinking water.
At the end of the wash, ll the tank with
fresh drinking water. Press the "OK"
button to conrm.
Press the "OK" button to conrm.
Remove the carafe, rinse and rell it with
fresh drinking water.
Press the "OK" button to conrm.
The cleaning cycle is activated.
The bar shows the cycle progress.
The rinse cycle is activated. The bar shows the cycle progress.
At the end of the cycle, the machine returns to the product brew menu page.
At this stage the carafe holes (A) are
lower than the couplings (C).
The carafe pins (B) are located at the
same height of the guides (D).
Insert the carafe by turning it towards the base through a round movement (as shown
in the gure), until it is hooked to the hole (E) located in the drip tray.
The carafe will be naturally back in
place.
REFILL WATER TANK
CARAFE WASH CYCLE
16
POUR THE DETERGENT
INTO THE CARAFE
AND FILL THE CARAFE
WITH FRESH WATER
CARAFE WASH CYCLE
14
FILL THE MILK CARAFE
WITH FRESH WATER
CARAFE WASH CYCLE
17
STEP 1/2
WASH CYCLE…
CARAFE WASH CYCLE
15
STEP 2/2
RINSING CYCLE...
CARAFE WASH CYCLE
19