16
1 2
3
CAPPUCCINO / LATTE MACCHIATO / MILK
PRODUCT BREWING
AT THE BEGINNING OF THE DISPENSING PHASE, THE MACHINE MAY PRODUCE SOME SPURTS OF MILK AND
STEAM: RISK OF SCALDING! ALWAYS WAIT FOR THE CYCLE TO END BEFORE REMOVING THE CONTAINER.
REFER TO THE SECTION "MILK CARAFE USE" SEE PAGE 12.
Place the cup or the container where the
milk-based product will be prepared.
Rotate the handle upper part of the
container on the cup. To avoid spilling
milk, always use cups of adequate size.
Select the desired milk product by
pressing the corresponding button: you
can select only one milk product at a
time.
The machine starts brewing. It grinds the
coee and heats up for milk dispensing.
In this case the ECOMODE function is set
to "ON" (see page 26).
Milk dispensing begins. Milk dispensing
can be stopped at any time by pressing
"STOP".
Milk dispensing can be increased by
pressing the button "+". In this case, NOT
frothed milk will be dispensed.
When brewing milk products, the machine dispenses the milk rst and then brews the coee. In this case, simultaneously brewing
a double product is not possible.
If the "OFF" button is pressed, the
ECOMODE function is deactivated and
set to "OFF".
(see page 26).
After that, when brewing beverages the
system will require less time for warm-
up. However, this will result in increased
energy consumption.
The ECOMODE function can
be re-activated by means of
the "MACHINE MENU" only
(see page 26).
4
A
B
5
6
To Next Page
Loading...
