34
The descaling cycle is activated.
The bar shows the cycle's progress.
If the containers need to be emptied,
press the "II" button.
Then, press the ">" button when the
container has been emptied and replaced.
At the end of the rst step, when the
descaling solution is nished, the
machine will require a tank rinse.
Rinse the water tank and rell it with
fresh drinking water.
Then, press the "OK" button.
Empty the drip tray placed under the
dispensing spout (page 38 - g. 2) and
then replace it on the machine.
Then, press the "OK" button.
Empty the drip tray placed under the
dispensing spout (page 38 - g. 2) and
replace it back onto the machine.
Then, press the "OK" button.
Place a container under the dispensing
spout and a container under the hot
water wand.
Then, press the "OK" button.
Fill half the carafe with fresh water
(page 36 - g. 7).
Insert the carafe and place it in the
brewing position. Then, press the "OK"
button.
Completely empty the carafe (page 36 -
g. 7) and ll it with fresh water.
Insert the carafe in the brewing position,
and then press the "OK" button.
A default amount of water is needed for the rinsing step. This allows performing an ideal rinse cycle to ensure the best conditions to
brew products. The message about lling the tank for the rinse cycle is normal, as it is part of the procedure.
MAINTENANCE
STEP 1/2
DESCALING CYCLE...
DESCALING CYCLE
7
STEP 1/2
DESCALING CYCLE...
DESCALING CYCLE
8
RINSE THE WATER TANK
AND FILL WITH
FRESH WATER
DESCALING CYCLE
9
RINSE THE WATER TANK
AND FILL WITH
FRESH WATER
DESCALING CYCLE
10
EMPTY DRIP TRAY PLACED
UNDER THE BREW GROUP
DESCALING CYCLE
4
EMPTY DRIP TRAY PLACED
UNDER THE BREW GROUP
DESCALING CYCLE
11
PLACE A CONTAINER
UNDER HOT WATER &
CARAFE DISP. SPOUTS
DESCALING CYCLE
6
FILL THE CARAFE HALFWAY
WITH FRESH WATER AND
INSERT IT IN
BREWING POSITION
DESCALING CYCLE
5
FILL THE MILK CARAFE
WITH FRESH WATER
DESCALING CYCLE
12
To Next Page
Loading...
