l Be careful while doing installation and maintenance of the filter flushing system Make sure that the
protective earth is well connected to the input terminal and to the motor body
l It is necessary to connect a two-pole switch between the power supply and the controller, 115VAC or
230VAC depends on the actual controller model.
l The supply point 115VAC or 230VAC (depends on the actual controller model), the circuit and connection
to the transformer must be performed according to “Field Electrical Regulations” by a licensed electrician
who is accredited with a license according to the Electrical Bill and security requirements.
l When using an internal transformer, minimal wire diameter must be 0.7mm. Check with standard
measuring equipment that there is no voltage in the electric circuit.
l Never cut, connect, or disconnect any wire at the controller’s vicinity.
l Make sure that the controller is not exposed to water splashes.
l Keep the keyboard cover closed at all times when not using the keyboard.
AMCFlushing Controller User Guide 5
Contents
To Next Page
Loading...
