GALI A-45 - First Start-Up; Air Feeding Circuit; Checking Assembly; Putting into Service



-
-
-14--14-


5.- FIRST START UP5.- FIRST START UP
5.1. - AIR FEEDING CIRCUIT5.1. - AIR FEEDING CIRCUIT
The tube should be cleaned with pressurised air before being coupled to the starter, tThe tube should be cleaned with pressurised air before being coupled to the starter, takingaking
particular care to prevent loose particles reaching the interior, due to particular care to prevent loose particles reaching the interior, due to welding the pipes or forwelding the pipes or for
any other reason.any other reason.
5.2. - CHECKING ASSEMBLY
5.2. - CHECKING ASSEMBLY
CaCarry out all trry out all the installation checks without he installation checks without pressure in the line.pressure in the line.
Check that the installation has been carried out in accordance with Check that the installation has been carried out in accordance with the general instructions provided abovethe general instructions provided above. In. In
particular, verify that the line particular, verify that the line has no passing restrictions, with regard to that indicated in has no passing restrictions, with regard to that indicated in point 4.3.point 4.3.
Test for leaks and check that the control circuit is not choked.Test for leaks and check that the control circuit is not choked.
Check that the air Check that the air receiver is charged and that the flow receiver is charged and that the flow valve is openedvalve is opened
5.3. – PUTTING INTO SERVICE5.3. – PUTTING INTO SERVICE
ALALWAYS RESPECT THE SAFETY INSTRUCTIONS WAYS RESPECT THE SAFETY INSTRUCTIONS OF THIS MANUALOF THIS MANUAL
Before conneBefore connecting cting the starter to an installation that is the starter to an installation that is in service, the air should alwaysin service, the air should always
be discharged from it.be discharged from it.
When the installation is completed, open the air feed valve carefully, observing if When the installation is completed, open the air feed valve carefully, observing if there is any leak; in there is any leak; in such asuch a
case, close it again, empty the case, close it again, empty the pipe slowly and clear the problem.pipe slowly and clear the problem.
Check the adjustment of the auto-start device (if Check the adjustment of the auto-start device (if installed), to ensure:installed), to ensure:
-the speed of the starter shaft never exceeds the value of 2500 r/min for type A45-the speed of the starter shaft never exceeds the value of 2500 r/min for type A45
-the starter stops working, once -the starter stops working, once the engine has attained a speed 1 to 1.5 the engine has attained a speed 1 to 1.5 times its ignitiontimes its ignition
speed.speed.
Check for correct meshing of tCheck for correct meshing of the driving pinion with the flywheel gear ring he driving pinion with the flywheel gear ring by jeans of severalby jeans of several
short starter impulses.short starter impulses.