-
-
-10--10-
4.- ASSEMBLY4.- ASSEMBLY
4.1.- INSTALATION4.1.- INSTALATION
Not allowed to modify the starter Not allowed to modify the starter when the security and performance can be adverselywhen the security and performance can be adversely
affected. In this case, the CE shall be void.affected. In this case, the CE shall be void.
The assembly has to done only by qualified personnel. Qualified means that the personnel areThe assembly has to done only by qualified personnel. Qualified means that the personnel are
formed, trained and familiar with the system.formed, trained and familiar with the system.
The personnel must have read and understood the instruction and safety regulations beforeThe personnel must have read and understood the instruction and safety regulations before
starting work.starting work.
It is It is recommenrecommended the starter be coupled to the ded the starter be coupled to the motor by means of a motor by means of a front flange.front flange.
To secure the starter to To secure the starter to the flange are used quality screws 8.8 the flange are used quality screws 8.8 and tightened with a torque determined (seeand tightened with a torque determined (see
picture below):picture below):
If the coupling has to If the coupling has to be made unavoidabbe made unavoidably by cylindrical ly by cylindrical cradle, it is cradle, it is necessary to check that this adaptsnecessary to check that this adapts
perfectly without producing local stress, assisting it if perfectly without producing local stress, assisting it if necessary with an annular clamp.necessary with an annular clamp.
The starter can be mounted on any position on the motor, the most recommendable being toThe starter can be mounted on any position on the motor, the most recommendable being to
locate the silencer below the drive pinion shaft.locate the silencer below the drive pinion shaft.
8 SECURING SCREWS M128 SECURING SCREWS M12
TIGHTETIGHTENING TORQNING TORQUE 84UE 84 Nm.Nm.
SPECIAL NUT M16x1,50SPECIAL NUT M16x1,50
TIGHTENING TORQUE 98TIGHTENING TORQUE 98
To Next Page
Loading...