-
-
-15--15-
Do not operate the starter at pressures higher than those inDo not operate the starter at pressures higher than those indicated in thedicated in the
characharacteristics cteristics of tof t he equipmehe equipment.nt.
The installation of a gauge connected to the pipe at The installation of a gauge connected to the pipe at the entrance of air to the entrance of air to the starter allowsthe starter allows
you to ensure there is no air remaining in the circuit and when the starter work mayyou to ensure there is no air remaining in the circuit and when the starter work may
determine the effective pressure of the supplydetermine the effective pressure of the supply
5.3.1.- PRIMING OF THE OIL INJECTION SYSTEM
5.3.1.- PRIMING OF THE OIL INJECTION SYSTEM
The priming operation shoulThe priming operation should always be carried out d always be carried out before the first before the first start. Never operate the starter start. Never operate the starter if theif the
lubrication system does not work lubrication system does not work properly.properly.
The servolubricator is an auto-priming unit. Before its first The servolubricator is an auto-priming unit. Before its first operationoperation, we advise, however, to , we advise, however, to proced as follows:proced as follows:
Adjust the injection volume to its maximum. Actuate 2-3 times Adjust the injection volume to its maximum. Actuate 2-3 times the push-button and then adjust again the oilthe push-button and then adjust again the oil
injection to the volume as per detailed below:injection to the volume as per detailed below:
DDuurraattiioon n pprreessss AA4455
<2 3<2 3
2 2 - - 6 6 44
6 6 - - 10 10 66
NeNever operaver operate the starter if the lubrite the starter if the lubri cation systcation system does not work em does not work properly.properly.
5.3.2.- LUBRICANTING OILS
5.3.2.- LUBRICANTING OILS
We strongly recommend employinWe strongly recommend employing for the g for the servolubricator oil of low viscosity servolubricator oil of low viscosity index, low freezeing point (lessindex, low freezeing point (less
than -25ºC= 13ºF), with good antirust properties and compatible with air humidity. Such oils than -25ºC= 13ºF), with good antirust properties and compatible with air humidity. Such oils are generally usedare generally used
for pneumatic tools.for pneumatic tools.
A type SAE A type SAE 10 motor oil can be 10 motor oil can be employed as well. In case of employed as well. In case of extremely low temperature (less than -20ºC= -4ºF),extremely low temperature (less than -20ºC= -4ºF),
special (Turbo Oil) oil should be used, however.special (Turbo Oil) oil should be used, however.
The servolubricator is lubricated with oil: TELLUS 32 oil.The servolubricator is lubricated with oil: TELLUS 32 oil.
To Next Page
Loading...