-
-
-5--5-
1.- INTRODUCTION1.- INTRODUCTION
These instructions are for installing GALI starters in These instructions are for installing GALI starters in the correspondent motor safely. If you read and the correspondent motor safely. If you read and respectedrespected
the following information, the team will have a proper operation and have a long service the following information, the team will have a proper operation and have a long service life.life.
The starters GALI The starters GALI operate safely, when they are operate safely, when they are properly selected, installed and maintained.properly selected, installed and maintained.
To ensure the safety of To ensure the safety of the starters have to take the starters have to take preventive measures. It is therefore absolutely necessary topreventive measures. It is therefore absolutely necessary to
fully read, understand and observe the dangers that may arise.fully read, understand and observe the dangers that may arise.
These instructions are made especially for These instructions are made especially for people involved in installation, dismantling, operation andpeople involved in installation, dismantling, operation and
maintenance.maintenance.
Respect the information in these instructions will ensure trouble-free operation techniquRespect the information in these instructions will ensure trouble-free operation techniques. If a es. If a failure to followfailure to follow
instructions, especially the chapter "Security", the starter could represent a mortal danger to instructions, especially the chapter "Security", the starter could represent a mortal danger to the operation andthe operation and
maintenance personnel.maintenance personnel.
2. - AIR STARTER SERIES A
2. - AIR STARTER SERIES A
The GALI air starters The GALI air starters are devices generally installed as auxiliary units of thermal motors or are devices generally installed as auxiliary units of thermal motors or turbines, for theirturbines, for their
start-up.start-up.
These starters are based on the principle of These starters are based on the principle of two geared rotors which are two geared rotors which are turned through the action of airturned through the action of air
pressure. This movement is subjected to the appropriate reduction to obtain a determined torque on the outputpressure. This movement is subjected to the appropriate reduction to obtain a determined torque on the output
shaft. To this shaft shaft. To this shaft the appropriate pinion is fitted and the movement thereof pulls the motor it the appropriate pinion is fitted and the movement thereof pulls the motor it is desired to start.is desired to start.
This pulling action is achieved by meshing the pinion of the This pulling action is achieved by meshing the pinion of the starter with a starter with a crown wheel usually fitted on thecrown wheel usually fitted on the
flywheel of the motor.flywheel of the motor.
The starters have internal mechanisms to achieve the meshing and avoid their start-up until it The starters have internal mechanisms to achieve the meshing and avoid their start-up until it has been carriedhas been carried
out successfully. They are out successfully. They are also provided with a also provided with a device that avoids reengagement.device that avoids reengagement.
2.1.- CE –CONFORMITY OF STARTERS GALI
2.1.- CE –CONFORMITY OF STARTERS GALI
The starters GALI The starters GALI are built, designed and tested are built, designed and tested according to Machinery Directive 98/37/CE and 2006/42/CE.according to Machinery Directive 98/37/CE and 2006/42/CE.
In addition to the directives and In addition to the directives and European standEuropean standards are also considered security policies and regulations forards are also considered security policies and regulations for
accident prevention.accident prevention.
All GALI starters All GALI starters are supplied with the “Declaration of incorporation of a quasi-machine”, according to Directiveare supplied with the “Declaration of incorporation of a quasi-machine”, according to Directive
2006/422006/42/CE (Annex II /CE (Annex II B)B)
To Next Page
Loading...