-
-
-9--9-
3.- TRANSPORT AND INFORMATION FOR ASSEMBLY3.- TRANSPORT AND INFORMATION FOR ASSEMBLY
3.1.- ESTATE DELIVERY3.1.- ESTATE DELIVERY
Before delivery, GALI starters Before delivery, GALI starters have been examined and tested under various have been examined and tested under various operating conditionoperating conditions. The s. The resultsresults
of these tests are of these tests are recorded in a protocol.recorded in a protocol.
All the starters are factory ready for service.All the starters are factory ready for service.
3.2.- TRANSPORT
3.2.- TRANSPORT
The packing which they are provided with for The packing which they are provided with for delivery facilitates transport and storage, at the same time as delivery facilitates transport and storage, at the same time as itit
protects the starter from protects the starter from possible blows or surface damages.possible blows or surface damages.
The geometry of the starter is such that it is easy to The geometry of the starter is such that it is easy to located fastening elemlocated fastening elements which allow its transport orents which allow its transport or
lifting.lifting.
Heavy objects. May cause muscle damage or back pain.Heavy objects. May cause muscle damage or back pain.
Always use an adequate and proper lifting technique.Always use an adequate and proper lifting technique.
Some heavy objects may fall and cause serious injury.Some heavy objects may fall and cause serious injury.
Personnel should wear safety shoes.Personnel should wear safety shoes.
3.3.- UNPACKING
3.3.- UNPACKING
Remove fully the packaging. Remove the plastics plugs that clog the holes for Remove fully the packaging. Remove the plastics plugs that clog the holes for the inlet nozzle and air outlets the inlet nozzle and air outlets forfor
accessories. These plugs are to prevent dirt from accessories. These plugs are to prevent dirt from inside the starter before final assembly.inside the starter before final assembly.
3.4.- STORAGE
3.4.- STORAGE
To prevent damage, the starters have to be To prevent damage, the starters have to be stored in a place stored in a place closed, protected against weatheclosed, protected against weather impact, dirt,r impact, dirt,
dust, moisture, chemicals, dust, moisture, chemicals, extreme temperatures and mechanical damage.extreme temperatures and mechanical damage.
The starters leave the factory with The starters leave the factory with anti-rust grease that protects the internal mechanisms.anti-rust grease that protects the internal mechanisms.
Nevertheless, it is recommended to store them in a Nevertheless, it is recommended to store them in a dry place.dry place.
In the event of In the event of the starter incorporating an electro valve, protect this particularly from impact. Ifthe starter incorporating an electro valve, protect this particularly from impact. If
the starter will rthe starter will remain dismantleemain dismantled a long time, d a long time, protect the pinion and output shaft of protect the pinion and output shaft of the starterthe starter
by means of oil by means of oil or grease to prevent rusting.or grease to prevent rusting.
Cover the access holes to Cover the access holes to the interior of the the interior of the starter appropriately, avoiding the possible entry ofstarter appropriately, avoiding the possible entry of
dirt or particles of dirt or particles of any type. Take particular care with any type. Take particular care with the caps themselves, which couldthe caps themselves, which could
introduce or release loose particles into the interior.introduce or release loose particles into the interior.
To Next Page
Loading...