Configuration
202 · Computer and console modules
Adjusting the scancode set of a PS/2 keyboard
If a key is pressed on the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scan code sets (sets 2 and 3) contain dif
-
ferent scan codes.
The console module interprets all inputs of the PS/2 keyboard with scan code set 2.
If the pipe (“|”) cannot be entered or if the arrow keys of the keyboard do not work
as expected, it is recommended to switch to scan code set 3.
How to select the scancode set of the PS/2 keyboard:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Keyboard/Mouse and press Enter.
3. Select PS/2 Scancode set and press F8 to select scancode sets 2 or 3.
4. Press F2 to save your settings.
5. Restart the console module to apply your changes.
Reinitialising USB input devices
After connecting a USB keyboard or mouse to the console module, the input devices
are initialised and can be used immediately.
Some USB input devices require a reinitialisation of the USB connection. Enable
the automatic reinitialisation of USB devices if a USB keyboard or mouse does not
respond to your inputs during operation.
How to enable/disable the reinitialisation of USB devices:
1. Press the Alt+Num (default) hotkey to open the OSD.
2. Select Keyboard/Mouse and press Enter.
To Next Page
Loading...
Need help?
General
