Gantner IDL 101 - Page 84

IDL 101
COMMUNICATION
82
HB_IDL101_E_V222.doc
Gantner Instruments Test & Measurement GmbH
Setpoint Variable:
After a writing command for this variable the new set value will be taken over.
Digital Output Variable (Host Output):
A writing command for this variable will set the corresponding variable to '1' or '0' respectively.
Register Type Content Length
variable information
1000 ............... ro ...............variable 1 variable type ............................. 2 byte
1001 ............... ro ...............variable 1 measuring principle.................... 2 byte
1002 ............... ro ...............variable 1 field length................................ 2 byte
1003 ............... ro ...............variable 1 decimals.................................... 2 byte
1004 ............... ro ...............variable 1 tare/reset.................................. 2 byte
1005..1007....... ro...............variable 1 units ......................................... 6 char
1007..1011....... ro...............variable 1 variable name............................ 20 char
1012..101F ....... ro ...............variable 1 reserve ..................................... 28 char
1000..101F variable information for variable 1
1020..103F variable information for variable 2
1040..105F variable information for variable 3
1060..107F variable information for variable 4
1080..109F variable information for variable 5
10A0..10BF variable information for variable 6
10C0..10DF variable information for variable 7
10E0..10FF variable information for variable 8
1100..111F variable information for variable 9
1120..113F variable information for variable 10
1140..115F variable information for variable 11
1160..117F variable information for variable 12
:
13E0..13FF variable information for variable 32
Coding <variable type>:
hex 00 Empty Variable (LE)
hex 01 Analog Input Variable (AI)
hex 02 Arithmetic Variable (AR)
hex 03 Digital Output Variable (DO)
hex 04 Digital Input Variable (DI)
hex 05 Setpoint Variable (VO)
hex 06 Alarm Variable (AL)
hex 09 PID Controller (CO)
hex 10 Analog Output (AO)