remove the SD card when the power switch is in the ON or
SET position. The camera uses a standard-size memory card to
save photos (in .jpg format) and/or videos (in .mp4 format). SD
and SDHC (High Capacity)/SDXC cards up to a maximum
512GB capacity are supported (Figure 7).
Figure 7: Inserting the SD Card
The following describes how to insert and remove the SD card:
Insert the SD card into the card slot with its label side
upwards. A "click" sound indicates that the card is installed
successfully. If the wrong side of the card is facing up, you
will not be able to insert it without force, there is only one
correct way to insert cards. If the SD card is not installed
correctly, the device will not display an SD card icon on the
screen in SET mode. Formatting the SD card by using the
camera's "Format" parameter in the menu settings before
using it for the first time is recommended, especially when a
card has been used in other devices.
To take out the SD card, just gently push in the card (do not
try to pull it out without pushing in first). The card is
released from the slot and ready to be removed when you
hear the click. Be sure the camera's power is switched OFF
before inserting or removing SD cards or batteries.
6. USING THE CAMERA
Once you've prepared your camera by properly installing
To Next Page
Loading...
