Try different distances and angles from the camera.
When the white motion indicator LED flashes in RED, it
indicates that the camera is able to sense the position.
However, if the LED doesn't blink, it means that the position
lies beyond the sensing range. (Note: The red light will blink
only when the motion is within the sensing area of the
central PIR sensor. The central sensor's sensing angle of
view is 60°. Each of the side sensors has a 30° angle of view,
which is only used to pre-activate the camera and accelerate
the triggering speed, there is no RED indicator blinking
whatever each of the side sensors detects motions.)
In these sensing test, the camera would take pictures once
motion captured. When you open the camera, the screen
shows the number of times triggered, you can review the
pictures on the screen.
The results of your testing will help you find the best placement
when mounting and aiming the camera. The height away from
the ground for placing the device should vary with the animal
size appropriately. In general, 3 to 6 feet is preferred.
You can avoid potential false triggers due to temperature and
motion disturbances in front of the camera by not aiming it at a
heat source or nearby tree branches or bush (especially on
windy days).
Do NOT install the camera behind the glass window as that is
not possible to sense any motion. Avoid setting the camera
towards glass objects.
9.3. SWITCHING ON THE CAMERA
The camera supports three working modes, "Motion Detection",
"Time Lapse" and "Hybrid".
(1) If you set the camera working mode as "Motion detection"
in the menu, once you switch to the ON mode, the camera will
countdown 30-second delay, and then will be ready to go into
To Next Page
Loading...
