standby (surveillance) and capture. Any motion detected by it
will trigger the capture of images as programmed in the menu.
Be sure you have read the descriptions of the Detection Delay
and PIR Sensitivity parameters.
(2) If you set the camera working mode as "Time Lapse" in the
menu, once you switch to the ON mode, the camera will be
ready to go into "Time Lapse" mode, then take images
periodically according to your preset "Timelapse Interval"
parameter, regardless of the settings "Detection Delay".
(3) If you set the camera’s working mode as "Hybrid" in the
menu, the camera will work according to the above two modes.
Before leaving the camera unattended, please check for the
following:
Are the batteries inserted with correct polarity and is their
power level sufficient?
Does the SD card have sufficient available space?
Is the power switch in the ON position?
To Next Page
Loading...
