Attention please: In the ON mode, the camera will
automatically enter SURVEILLANCE mode if there is no
operation (key pressing) within 3 minutes. Then the camera
will perform as your settings in the menu.
In the ON mode, you can connect the camera to a computer's
USB port to download your images.
6.3. SURVEILLANCE Mode
Any time after the batteries have been inserted, you can switch
on the camera. When the START button is pressed, the camera
will enter into the SURVEILLANCE mode. If the Mode in the
settings is set as "Motion Detection", the camera will count
down a 30-second delay and then be ready to capture images. If
the Mode is set as "Time Lapse", there will be no 30-second
counting down, and the camera will be ready to enter Time
Lapse.
Once in the SURVEILLANCE mode, no manual controls are
needed or possible (the control keys have no effect). The
camera will take photos or videos automatically (according to
its current parameter settings).
TIP: You can press the START button again to wake up the
camera and reprogram your camera if required.
7. CELLULAR CONNECTION
7.1. Download GardePro Mobile App
Before using the cellular functionality, please download the
'GardePro Mobile' app.
To Next Page
Loading...
