Garmin Diamond DA40 - Page 74

Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
190-00592-06 Rev. A62
FLIGHT INSTRUMENTS
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Figure 2-26 Typical LNAV and LNAV+V Approach CDI Scaling
1.0 nm
2 nm
350 ft
angle set
by system
0.3 nm
FA F
CDI Full-scale Deflection
CDI scale is set to the smaller of 0.3 nm
or an angle set by the system
CDI scale varies if VTF is activated
Figure 2-27 Typical LNAV/VNAV and LPV Approach CDI Scaling
1.0 nm
2 nm
FA F
0.3 nm
course width
Landing
Threshold
CDI Full-scale Deflection
angle based
on database
information
CDI scale varies if VTF is activated
•Whenamissed approach is activated, the CDI scale changes to 0.3 nm.
•Thesystemautomaticallyswitchesbacktoterminal scaling under the following conditions:
- The next leg in the missed approach procedure is not aligned with the final approach path
- The next leg in the missed approach procedure is not CA, CD, CF, CI, CR, DF, FA, FC, FD, FM, IF, or TF
- After any leg in the missed approach procedure that is not CA or FA
Flight Phase Annunciation Automatic CDI Full-scale Deflection
Departure DPRT 0.3 nm
Terminal TERM 1.0 nm
Enroute ENR 2.0 nm
Oceanic OCN 2.0 nm
Approach
(Non-precision)
LNAV
1.0 nm decreasing to 350 feet depending on
variables (see Figure 2-26)
Approach
(Non-precision with
Vertical Guidance)
LNAV + V
Approach
(LNAV/VNAV)
L/VNAV
1.0 nm decreasing to a specified course width, then
0.3 nm, depending on variables (see Figure 2-27)
Approach
(LPV)
LPV
Missed Approach MAPR 0.3 nm
Table 2-1 Automatic GPS CDI Scaling