3-90 Pilot’s Guide 190-02488-01 Rev. B
Navigation
Autopilot Outputs
Engage the autopilot heading mode and set the heading bug appropriately to use the
autopilot on heading legs using the autopilot’s NAV, GPSS, or APR mode. Not all
autopilots follow guidance on these leg types, Some revert to a roll only or wings level
mode.
FEATURE REQUIREMENTS
• Availability dependent upon configuration
FEATURE LIMITATIONS
• Applicable to King KAP 140 and KFC 225 autopilots
Outputs for the King KAP 140/KFC 225 autopilot units require manual activation.
If configured, this function prompts you to enable autopilot outputs during the
approach procedure.
Once enabled, the unit provides guidance information consistent with what the
autopilot expects (i.e., angular CDI scaling and glideslope capture for LPV or other
vertically guided GPS approaches).
ENABLE AUTOPILOT OUTPUTS
1. Acknowledge the advisory message.
2. Tap Enable APR Output.
3. Follow the unit provided guidance.
Enable APR Output Advisory
GNX 375 shown as typical.
To Next Page
Loading...
Need help?
General
