35
WARNING: Always unplug the appliance before cleaning. Do not immerse the power base
or power cord in water or other liquids or spill any liquids on the power base or power cord.
Do not place the appliance or any part of it or power cord in an automatic dishwasher.
4. Before first use and after a longer period of storage, clean the appliance and its parts.
(See: ´Care and Cleaning`)
Operation
WARNING: Always ensure that the appliance and all its parts and accessories are out of
reach of young children. The appliance is intended for grinding roasted coffee beans.
Thus, the milling works and burr sleeve can cause severe injuries when handled improperly.
Only place the appliance on a stable, dry, level, and clean surface. Do not place the appli-
ance on inclined surfaces where it can fall over, to avoid damage. Do not place any clothes
or tissue or other foreign objects on or under the appliance during operation, to avoid risk of
fire, overheating, or electric shock. Do not block the ventilation slots at the bottom and rear of
the power base. During operation, the operating elements (see: ´Knowing Your Design Coffee
Grinder Advanced Pro`) must be accessible all the time.
Ensure to keep the appliance in an appropriate distance of at least 20 cm on each side to the
edge of the working space and any other objects. During operation leave at least 50 cm of
free space above the appliance for unhindered access.
Before assembling the appliance, always ensure that all parts are in proper working order.
(See: ´General Safety Instructions`) Do not use any damaged or unsuitable parts to avoid risk
of injuries and damage.
Do not use violence when removing the bean hopper. The bean hopper is locked securely
for operation. Thus, always release the bean hopper lock, before removing the bean hopper.
Exclusively use the appliance for grinding roasted coffee beans. The appliance is not suited for
chopping or grinding any other food or materials.
To avoid disadvantageous reduction of quality and flavour of your coffee, you should regularly
clean the appliance (See: ´Care and Cleaning`).
Preparing the Appliance for Use
1. Place the appliance on a stable, flat, dry and level surface near a suitable wall power outlet.
(See: ´Important Safeguards for Electrical Appliances`)
2. Ensure that the burr sleeve is assembled correctly in the milling works. There is a red arrow
on the burr sleeve that must point to the LOCK mark at the brim of the milling works. For
further instructions see Reassembling the Appliance.
3. Place the bean hopper over the milling works. See also: ´Reassembling the Appliance`.
For this, turn the bean hopper lock to UNLOCK position (turned counter-clockwise). Then
place the bean hopper on the milling works and turn it gently until it settles down. Then, turn
the bean hopper lock 90° clockwise into LOCK position.
Tip: If the bean hopper has not been locked into position, the message “LOCK BEAN HOP-
PER” will be displayed on the screen. Additionally, operation of the appliance is disabled for
safety.
To Next Page
Loading...
Need help?
General
