41
Care and Cleaning
Regular cleaning helps the grinder achieve consistent grinding results which is especially
important when grinding for the use with espresso machines. Additionally, you avoid disad-
vantages to flavour and taste due to any remainder left in the grinder.
WARNING: Always ensure that the appliance and any parts and accessories of it are out
of reach of young children. Always unplug the appliance, before moving, disassembling,
or cleaning the appliance.
The appliance is intended for grinding roasted coffee beans. Therefore, the milling works and
the burr sleeve can cause severe injuries when handled improperly. Do not hold your fingers or
any foreign objects into the grinder, and do not poke in the grind outlet, while the appliance
is connected to the power supply. Always unplug the appliance before moving, disassembling
or cleaning the appliance.
CAUTION: Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or
any corrosive chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid da-
mage to the surfaces. Do not use any hard or sharp-edged objects for cleaning. Do not immer-
se the power base or power cord in water or any other liquid. Do not spill or drip any liquids
on or in the power base or power cord to avoid risk of fire and electric shock. Do not clean
the appliance or any part of it in an automatic dishwasher. Do not use violence!
Do not clean the milling works with damped brushes. Coffee powder will stick together, and
therefore clog up and block the milling works, when getting in contact with moisture.
For operation the bean hopper is locked on the power base. Do not use violence, when att-
empting to remove the bean hopper or release the lock, to avoid damage.
Disassembling the Appliance
1. Unplug the appliance and remove the bean hopper lid.
2. Turn the bean hopper lock counterclockwise to unlock the bean hopper. Then lift the bean
hopper up and out.
3. Remove the coffee beans from the bean hopper. Then reassemble the bean hopper and turn
the bean hopper lock clockwise to lock the bean hopper in place.
4. Replace the bean hopper lid and insert the plug into the power outlet.
5. Press and hold the START/CANCEL button to run the milling works until it is empty, with no
more coffee powder coming out of the grind outlet.
6. Unplug the appliance, remove the bean hopper lid.
7. Unlock and remove the bean hopper.
WARNING: To avoid injuries, always unplug the appliance (screen gets dark), before gra-
sping in the milling works.
8. Remove the burr sleeve. For this, grasp the metal shackle of the burr sleeve, and turn the
burr sleeve counter-clockwise until the red arrow on the burr sleeve is pointing to ALIGN.
Then lift the burr sleeve up and out.
9. Remove the grind catch tray from the power base. The grind catch tray is held in place via
a magnet. You can simply pull it out.
To Next Page
Loading...
