40
The milling works start
but no ground coffee
comes from grind outlet
No coffee beans in
bean hopper!
Fill bean hopper with fresh coffee beans.
Milling works or
bean hopper is
blocked.
Remove bean hopper and burr sleeve.
Inspect bean hopper and milling works
for blockage. Remove obstacles. Repla-
ce parts and try again.
The coffee is ground
irregularly with too large
pieces.
The burr sleeve
is missing or not
locked correctly.
Ensure assembling the appliance correctly
according to the instructions in section
´Preparing the Appliance for Use`. Do
not forget to insert and correctly lock the
burr sleeve.
Motor starts but operates
with a loud racket noise
Milling works or
bean hopper outlet
is blocked with
foreign item.
Remove bean hopper, inspect bean
hopper, burr sleeve and milling works
and remove any foreign object.
Moistened coffee
powder is blocking
the milling works.
Clean burr sleeve, milling works
and bean hopper (see: ´Care and
Cleaning`).
Leave all parts dry thoroughly before re-
assembling. You can use a hair dryer to
blow air into the milling works to dry.
Not enough/too much
coffee grind
Amount settings
requires adjustment.
Press AMOUNT button to change grind
amount.
Use ADJUST AMOUNT dial to fine tune
the amount for MORE or LESS.
The Portafilter overfills. It is normal for the
correct amount of
coffee to appear
overfilled in your
portafilter.
Tamper the coffee powder. Untamped
coffee can reach three times the volume
of tamped coffee.
The GRIND SIZE dial is
tight
Run milling works empty briefly by pres-
sing the START/CANCEL button whilst
turning the dial.
You cannot assemble the
bean hopper or the bean
hopper will not stand
tight on the grinder.
The bean hopper
lock is in wrong
position.
Turn the bean hopper lock to the UN-
LOCK position before assembling the
bean hopper. Then try again.
You cannot unlock the
bean hopper.
Coffee beans block
the bottom of the
bean hopper.
Activate the grinder for a short moment
to work the beans lose. Then try again.
The appliance is connec-
ted to the power supply,
but the screen is dark.
The energy saving
feature is active.
Simply press a button of the operating
elements.
To Next Page
Loading...
