Gate Titan User Manual

44
21. Prepare selector plate. If the selector plate does not have copper connector, you need
to modify it. The black surface does not reect light, so sensors cannot work properly.
22. In order to modify the black plate, use a sticker from the
installation kit. At rst, try to use the ‘middle’ sticker.
Notice
If the selector plate has copper connector, do not make any modications.

Gate Titan Specifications

General

MOSFET	Yes
Battery protection	Yes
Trigger sensitivity adjustment	Yes
Pre-cocking	Yes
ROF control	Yes
Active brake	Yes
Diagnostic system	Yes
Programmable	Yes
Cycle Detection	Yes
Compatibility	V2 Gearbox
Low current consumption in sleep mode	0.2mA
Connectivity	USB-Link, Blu-Link
Fire Modes	Semi, Burst
Bluetooth support	Yes