17
• The monitor is not positioned too close to another monitor,
electric fan, fluorescent light, metal shelf, or laser printer.
u Press the degauss button on the control panel to demagnetize the
screen.
Image is not sized or centered properly
Use the size and center controls to adjust the display image as desired.
Refer to “Adjusting display setting” on page 9 for information about
the OSD control system.
Image cannot be adjusted full-screen
Some video modes used by your monitor produce images that cannot
be adjusted all the way out to the bezel edge (the edge where the
screen glass and monitor case meet).
This condition does NOT indicate that the monitor is defective. Try
selecting a different refresh rate or resolution setting, as described on
page 11.
Troubleshooting
EV500-u5.p65 1999/9/16, PM 05:4117
To Next Page
Loading...
Need help?
General
