CHAPTER 1: Using Your Gateway Flat-Panel Monitor
8
You can rotate the screen clockwise 90° to change between landscape and portrait views. For
information on automatically rotating the display image as you manually rotate the monitor, see
“Using landscape and portrait modes” on page 21.
Adjusting monitor height tension
The stand is factory adjusted to maintain the height for your monitor. However, if it does not
stay in place when you let go, you need to change the stand’s height tension. You also need to
adjust the stand if the amounts of force required to raise and lower the monitor are not equal.
To adjust your monitor’s height tension:
1 Press the screwdriver access hole cap from below the base to remove it from the base.
Portrait modeLandscape mode
Screwdriver access cap
8512114.book Page 8 Friday, January 12, 2007 2:33 PM
To Next Page
Loading...
Need help?
General