www.gateway.com
13
To remove the speaker bar:
1 Disconnect all audio and power cables from the speaker bar.
2 Press the two release buttons on the back of your monitor, then pull the speaker bar down.
Starting the monitor
Using the EzTouch menu buttons
This monitor features an on-screen display (OSD) and EzTouch menu buttons that let you turn
the monitor on and off, and adjust contrast, brightness, and other settings. For more information
on EzTouch buttons, see “Using the EzTouch menu buttons” on page 14.
Turning on the monitor
To start the monitor:
1 Press the power button on the front of monitor. The power LED on the power button
changes from purple (off) to blue (on).
2 Turn on your computer. After your computer is running, the power LED on the monitor’s
power button should be blue. Allow about 10 seconds for the display image to appear. If
the power LED is not blue or you do not see a display image, check the connections. For
more troubleshooting information, see “Troubleshooting” on page 25.
3 Adjust the tilt of the monitor for the best viewing angle.
4 After you see the Windows desktop, press the (Menu) button on the front of your
monitor, then press (Auto) to automatically adjust your display image to the ideal
settings.
Release button
8512114.book Page 13 Friday, January 12, 2007 2:33 PM
To Next Page
Loading...
Need help?
General