CHAPTER 1: Using Your Gateway Flat-Panel Monitor
4
Connecting video inputs
To connect video sources to your monitor:
1 Position your computer and the monitor so you can reach the back of each.
2 Connect the blue VGA video cable to the blue VGA video connector under the back of
the display.
- OR -
If your computer has a digital video connector (DVI), connect a DVI video cable to the white
connector under the back of the display.
3 Make sure that your computer is turned off, then connect the other end of the video cable
to the matching video port on the back of your computer.
Tip
Rotate the screen 90° to make it easier to connect the cables.
8512114.book Page 4 Friday, January 12, 2007 2:33 PM
To Next Page
Loading...