71
232001240G(08)
Adjustment Bar/ Power Level (Stamp Page)
Another important aspect of creating a stamp is setting the slope level of the shoulder. The
shoulder is the section from the “contact section” of the stamp to its base. This function allows
you to adjust the slope for the shoulder sections of your stamp. By sliding the sliders or directly
input of power levels, you will be able to change the slope of the shoulder.
NOTE
The visual representations of the Pitch and Shoulder Levels in the Spirit Series driver are
an exaggerated representation to allow for easy visual guidance and precise input.
Remember we are working with distances less than 1 mm here.
Base of ridge (pitch)
Slope of ridge (shoulder level)
Bridge: contact area of the
stamp
To Next Page
Loading...
