GDC SX-2000 - Automation Setup for eCNA Devices

SX-2000 Installation Manual 11/8/2010
GDC Technology Ltd. Page 33 of 42
Figure 34 Projector automation device setup
Figure 35 Automation settings for projector device
3.3.6 Automation setup for eCNA devices
The SX-2000 server supports the eCNA-10 automation system. Follow the steps below to
configure an eCNA device in the server automation interface.
7. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is “eCNA”. Set the device type to “eCNA_IO” (see Figure 36).