Need help?Do you have a question about the GDC SX-2000 and is the answer not in the manual?
Overview of the front and rear panels of the SX-2000 server.
Guidelines for mounting and positioning the SX-2000 server unit.
Step-by-step instructions for installing hard drives into the server's hot-swap bays.
Details the essential cable connections required for the SX-2000 server operation.
Procedure for installing the IMB into the projector and connecting it to the SX-2000 server.
Steps for physically installing the IMB within the projector and connecting it.
Identifies the components provided with the GDC Integrated Media Block.
Instructions for removing interface boards from projectors before IMB installation.
Guide on how to physically insert the IMB unit into the projector.
Details the PCI-e and network cable connections between the IMB and SX-2000 server.
Steps for connecting PCI-e and network cables to the IMB on the projector.
Steps for connecting PCI-e and network cables to the SX-2000 server.
Configuration steps for Series 2 projectors to work with the GDC IMB.
Configuration details for Barco Series 2 projectors with the GDC IMB.
Steps for configuring NEC Series 2 projectors using the Digital Cinema Communicator.
Procedure for setting up Christie Series 2 projectors for IMB compatibility.
Configuration of 3D macros and input settings for Christie Series 2 projectors.
General configuration steps for the SX-2000 server and its network settings.
Instructions for configuring IP addresses for the server's network interface cards (NICs).
Configuring projector and IMB IP addresses and marriage on the SX-2000 server.
Setting up the server for ingesting content from external sources like USB or FTP.
Procedure for setting up a USB drive as a content ingest source.
Steps for configuring an FTP server as a content ingest source.
How to choose the desired ingest source from the available options.
Instructions on how to change the time zone settings for the SX-2000 server.
Connecting the server's audio output to the USL ECI-60.
Configuring audio connection with the Yamaha DA824.
Connecting the server's audio output to the USL DAX-602.
Connecting the server's audio output to the Dolby DMA8.
Connecting the server's audio output to the Dolby CP650.
General steps for setting up an automation device on the SX-2000 server.
Procedure for adding event labels and associated automation actions.
Scheduling automation events to execute at specific times or intervals.
Configuration of GPIO automation device when a GPIO card is installed.
Configuring projector devices (Barco, Christie, NEC) for automation.
Setting up the eCNA-10 automation system within the server interface.
Configuration of JNIOR Model 310 automation devices in the server interface.
Setting up Christie ACT devices for automation within the server interface.
Configuration of Dolby CP650 sound processor for automation.
Setting up USL DAX sound processors for automation in the server interface.
Configuration of USL JSD devices for automation in the server interface.
Setup and wiring for the Component Engineering TA-10 for automation.
To Next Page
General
