GDC SX-2000 - Automation Setup for USL DAX Devices

SX-2000 Installation Manual 11/8/2010
GDC Technology Ltd. Page 38 of 42
5. Click the [Save] button to save configured settings.
Figure 42 Dolby CP650 automation device setup
Figure 43 Automation settings for Dolby CP650 device
3.3.10 Automation setup for USL DAX devices
The SX-2000 server supports automation for USL DAX sound processor. Follow the steps below
to configure a USL DAX device in the server automation interface.
1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is “DAX”. Set the device type to “USL-DAX” (see Figure 44).
2. Click [OK] and set up the device parameters for the USL DAX device.