Programming the Panel 44
User Codes (10nn0--
nn=user 00 thru 15)
User Codes (Default=none)
User Codes perform basic
arming and disarming func-
tions. The system allows up
to 16 user codes (user num-
bers 00-15). User numbers
that show **** indicate no
code is currently pro-
grammed for that user num-
ber.
¾
To program Regular User Codes:
1. With the display showing USER CODES, press ƒ and the display shows REGULAR USER
CODES
.
2. Press
ƒ and the display shows USER nn (first available user number).
3. Press
A or B to select the desired user number, then press ƒ. The display shows
USER nn - nnnn.
4. Enter a 4-digit user code and the display flashes
USER nn - nnnn (new code). Press ƒ to accept
the new setting.
¾
To delete Regular User Codes:
1. With the display showing USER CODES, press ƒ and the display shows REGULAR USER
CODES
.
2. Press
ƒ and the display shows USER nn (first available user number).
3. Press
A or B to select the desired user number/user code you want to delete, then press ƒ.
The display shows
USER nn - nnnn.
4. Enter a 4-digit code that is the same as the system master code. With the display flashing the
entered code, press
ƒ and the display shows USER nn - **** (no code).
Direct Bypassing (10nn1-
-nn=user 00 thru 15)
User Codes (Default=off)
User Codes perform basic arm-
ing and disarming functions. The
system allows up to 16 user
codes (user numbers 00-15).
User numbers that show ****
indicate no code is currently pro-
grammed for that user number.
¾
To turn user code Direct Bypassing off or on:
1. With the display showing USER CODES, press ƒ and the display shows REGULAR USER
CODES
.
2. Press
ƒ and the display shows USER nn (first available user number).
3. Press
A or B to select the desired user number, then press ƒ. The display shows
USER nn - nnnn.
4. Press
B and the display shows DIRECT BYPASSING OFF/ON (current setting).
5. Press
1 (off) or 2 (on) and the display flashes the entered setting. Press ƒ to accept the
new setting.
System Tests (10nn2--
nn=user 00 thru 15)
User Codes (Default=off)
This setting determines whether
or not a user code can perform
phone and sensor tests.
¾
To turn user code System Tests off or on:
1. With the display showing USER CODES, press ƒ and the display shows REGULAR USER
CODES
.
2. Press
ƒ and the display shows USER nn (first available user number).
3. Press
A or B to select the desired user number, then press ƒ. The display shows
USER nn - nnnn.
4. Press
B until the display shows SYSTEM TESTS OFF/ON (current setting).
5. Press
1 (off) or 2 (on) and the display flashes the entered setting. Press ƒ to accept the
new setting.