Using the clock and timer.
Not all features are on all models.
IVlakesure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oventiming functions
to work properly. Thetime of day cannot be
changed during a timed baking or self-cleaning
cycle.
ry] Touchthe Clock pad.
[_ Touchthe number pads.
Touch the number pads the same way you
read them. For example,to set 12:34,touch the
number pads 1,2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the Clock pad, the
display reverts to the original setting. Ifthis
happens, touch the Clock pad and reenter the
time of day.
[] Touchthe Start pad until the time of day
shows in the display.Thisenters the time
and starts the clock.
Tocheckthe time of day when the display
isshowing other information, simply touch the
Clock pad.Thetime of day shows until another
pad istouched.
KITCHEN
TIMER I
ON/Or_
rqrqN rqrq
C_r.o_Lockout
START
The timer is a minute timer only,
The Clear/Off pad does not affect
the timer.
To Set the Timer (For lower oven only.)
Thetimer does not control oven operations.
The maximum setting on the timer is9 hours
and 59 minutes.
%
r21
Touchthe KitchenTimerOn/Off pad.
Touchthe number pads until the amount
of time you want shows in the display. The
maximum time that can be entered in
minutes is 59.Times more than 59
minutes should be changed to hours and
minutes. Forexample, to enter 90 minutes
as 1 hour 30 minutes, touch 1,3 and 0 in
that order.
Ifyou make a mistake, pressthe Kitchen Timer
On/Offpad and begin again.
@
Touchthe Start pad. After pressing the
Start pad, Set disappears;this tells you the
time iscounting down, although the
display does not change until one minute
has passed.
%
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 secondsuntil the Kitchen Timer
On/Off pad is touched.
The6-second tone can be canceled by
following the steps in the Special features of
your oven control section under Tonesat the
Endof aTimed Cycle.
To Reset the Timer
Ifthe display is still showing the time remaining,
you may change it by touching the Kitchen
Timer On/Off pad and then touching the
number pads until the time you want appears
in the display.
If the remaining time is not in the display (clock,
delay start or cooking time are inthe display),
recallthe remaining time by touching the
Kitchen Timer On/Off pad and then touching
the number pads to enter the new time you
want.
To Cancel the Timer
Touch the Kitchen Timer On/Off pad twice.
14
Power Outage
If a flashing time isin the display,you have
experienced a power failure. Resetthe clock.
Touch the Clock pad once to reset. Enterthe
correct time of day by touching the appropriate
number pads.Touch the Start pad.
To Next Page
Loading...
