EasyManua.ls Logo

GE Appliances JGB850 - Self-Cleaning

GE Appliances JGB850
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Usingthe self-cleaning upper and lower ovens.
Theoven door must:be closedand all controls set correctlyfor the cycleto work properly.
GEAppliances.com
Wipe up heavy soil on the oven
bottom.
DO hand clean
DO NOT hand inside door frame
clean gasket, and glass.
DO hand clean oven frame.
Before a Clean Cycle
Forthe first self-clean cycle,we recommend
venting your kitchen with an open window
or using a ventilation fan or hood.
Removeany broiler pan,broiler grid, all
cookware, probe and any aluminum foil
from the oven-they cannot withstand the high
cleaning temperatures.
NOTE:
Ifyour oven is equipped with nickel
oven racks, remove them before you begin
the self-clean cycle.
Ifyour oven is equipped with gray porcelain-
coated oven racks,they may be left in the
oven during the self-clean cycle.
Soilon the front frame of the range and
outside the gasket on the front frame will
need to be cleaned by hand. Clean these
areas with hot water, soap-filled scouring
pads or cleansers such as Soft ScrubQ.Rinse
well with clean water and dry. Wipe off
the flat inner door with soapy water and a
sponge.
Do not clean the gasket. The fiberglass
material of the front frame gasket cannot
withstand abrasion. It is essentialfor the gasket
to remain intact. Ifyou notice it becoming worn
or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Hake surethe oven light bulb cover isin place
and the oven light isoff.
IMPORTANT'.The health of some birds
isextremely sensitiveto the fumes given
off during the self-cleaning cycle of any range.
Hove birdsto another well-ventilated room.
NOTE:Usecaution when opening the upper
and lower oven after theself-cleancycle has
ended.Theovenmay still be hot.
i START J
NOTES:
Thesurface burners must
be turened off prior to the
self-clean start time
Both ovens cannot be self-
cleaned at the same time.
Cooktop burners and the oven
not in self-clean mode will not
start during self-clean cycle.
How to Set the Upper Oven for Cleaning
Theoven door must be closed and all controls
set correctly for the cycle to work.
[] Rotateupper oven knob to self-clean
position.
[] Touch the Start pad.
Doorswill lock automatically. The display will
show the clean time remaining. If the upper
door is not locked end remaining clean time
is not displayed, within 1 minute of initiating
the cycle rotate the knob to the Off positioin
and open both doors for 10 minutes. Repeat
step 1. Itwill not be possible to open the oven
door until the temperature drops below the
lock temperature and the LOCKED DOOR light
goes off.
Theoven shuts off automatically when the
clean cycle iscomplete.
r_ Whenthe LOCKEDDOOR light isoff, the
door will unlock automatically.
r_ Rotate knobto the off position
Thewords LOCKDOORwill flash and the
oven control will signal if you set the clean
cycle and forget to closethe oven door.
Tostop a clean cycle,touch the Clear/Off
pad then turn the oven control knob to the
OFFposition. After some period of time,the
LOCKEDDOOR light will go off.Thiswill
indicate that the oven has cooled below
the locking temperature and gas isable to
flow to the cooktop. The doors will unlock
automatically.
After you complete the first oven clean cycle,
you can start the second oven clean cycle.
27

Related product manuals