Using the clock and timer. GEAppliances.com
Not all features are on all models.
/J c ocK
Make sure the clock is set to the
correct time of day.
To Set the Clock
Theclock must be set to the correct time of day
for the automatic oventiming functions to work
properly.Thetime of day cannot be changed
during a timed baking or self-cleaning cycle.
[] Touchthe Clock pad.
[] Touchthe number pads.
Touch the number pads the same way you
read them. Forexample,to set 12:34,touch the
number pads 1,2,3 and 4 in that order.
If number pads are not touched within one
minute after you touch the Clock pad, the
display revertsto the original setting. If this
happens,touch the Clock pad and reenter the
time of day.
[] Touch the Start pad until the time of day
shows in the display.Thisenters the time
and starts the clock.
Tocheck the time of day when the display is
showing other information, simply touch the
Clock pad.Thetime of day shows until another
pad istouched.
START
The timer is a minute timer only.
The Clear/Off pad does not affect
the timer.
To Set the Timer
Thetimer does not control oven operations.
The maximum setting on the timer is9 hours
and 59 minutes.
%
Touchthe Kitchen Timer On/Off pad.
Touchthe number pads until the amount
of time you want shows in the display.The
maximum time that can be entered in
minutes is59.Times more than 59
minutes should be changed to hours and
minutes. Forexample, to enter 90 minutes
as ! hour 30 minutes, touch 1, 3 and 0 in
that order.
Ifyou make a mistake,pressthe Kitchen Timer
On/Offpad and begin again.
@
Touch the Start pad. After pressingthe
Start pad, Set disappears; this tells you
the time is counting down, although the
display doesnot change until one minute
haspassed.
%
When the timer reaches :00, the control
will beep 3 times followed byone beep
every 6 seconds until the Kitchen Timer
On/Off pad istouched.
The6 second tone can be canceled by
following the steps in the Specialfeaturesof
your oven control section under Tonesat the
End of a TimedCycle.
To Reset the Timer
Ifthe display isstill showing the time remaining,
you may change it by touching the Kitchen
Timer On/Off pad, then touch the number
pads until the time you want appears in the
display.
If the remaining time is not in the display (clock,
delay start or cooking time are inthe display),
recallthe remaining time by touching the
Kitchen Timer On/Off pad and then touching
the number padsto enter the new time you
want.
To Cancel the Timer
Touch the Kitchen Timer On/Off pad twice.
Power Outage
Ifa flashing time is in the display, you have
experienced a power failure. Reset the clock.
Touch the Clock pad once to reset. Enterthe
correct time of day bytouching the appropriate
number pads.Touch the Start pad.
15
To Next Page
Loading...
