EasyManua.ls Logo

GE Appliances PGB900 - Racks

GE Appliances PGB900
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GEAppliances.com
Oven Racks
All oven racksmay be cleaned by hand with an
abrasive cleaner or steel wool. After cleaning,
rinsethe rackswith cleanwater and dry with a
clean cloth. Grayporcelain-coated oven racks
may remain in the oven during the self-cleaning
cyclewithout being damaged. If nickel-plated
oven racks remain inthe oven during the self-
cleaning cycle,they will losetheir luster and
become hard to slide. It will be necessary to
grease all oven rack side edgeswith a light
coating of vegetable oil after cleaning them by
hand or in the oven.This will help maintain the
easeof sliding the racks in and out of the oven.
d
Extension Rack (on some models)
Extensionracks may be cleaned by hand with
an abrasive cleaner or steelwool. During
cleaning, be careful not to allow water or
cleaner to enter the extension slideson the
sides ofthe rack.
NOTE:Do not cleanin a dishwasher.
If the rack becomes hard to remove or
replace, wipe the oven rack supports with
cooking oil.Do not wipe cooking oil on the
slides.
Ifthe rack becomes difficult to slideor if the
paddle isdifficult to actuate, the rack may need
to be lubricated usingthe Graphite Lubrication
shippedwith your oven.To order additional
Graphite Lubrication,call our National Parts
Centerat 800.626.2002and reference
WBO2TIO$O$.
Rackright-side-up
To lubricate the slides:
NOTE:Do not spray extension rack with cooking
spray or other lubricant sprays.
[71 Removethe rack from the oven.See
ExtensionRackin the Usingthe oven
section.
[] Fullyextend the rack on a table or
countertop. Newspaper may be placed
underneath the rack for easy cleanup.
@
Ifthere isdebris in the slidetracks, wipe it
away using a paper towel.
NOTE:Any graphite lubricant wiped away
must bereplaced- seesteps4 through 7.
r_ Shakethe graphite lubricant before
opening it. Starting with the left slide
mechanism of the rack, placefour (4)
small drops of lubricant on the two (2)
bottom tracks ofthe slideclose to the
bearing carriers.
r_ Repeatfor the right slide mechanism of
the rack.
r_ open and closethe rack several times to
distribute the lubricant.
[-Z---]Replacethe cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3,4,5 and 6.
[] Closethe rack, turn rack right-side-up and
place in the oven. SeeExtensionRackin
the Usingthe ovensection.
To lubricate the paddle:
Shakelubricant and
apply to the moving
parts of the paddle
mechanisms as shown.
39

Related product manuals