Installation Instructions
DIMENSIONS AND CLEARANCES
Provide adequate clearances between the range and adjacent combustible surfaces. These dimensions must be
met for safe use of your range. The location of the electrical outlet and pipe opening (see Gas Pipe and Electric
Outlet Locations) may be adjusted to meet specific requirements.
The range may be placed with 0" clearance {flush) at the back wall. {Some models will not fit flush.)
For island installation, Models CGS975 and CGS985,maintain 2-1/2" minimum from cutout to back edge of
countertop and 3" minimum from cutout to side edges of countertop.
*lV]odels PGB900,
PGB910, PGB915,
PGB930, PGB935,
JGB295, JGB296,
JGB600, JGB605,
JGB810 and JGB840
require only 3"
minimum clearance
to left wall. 18"-
"nm.mto1!!
cabinets on
either side | 3 0"
of the range F
30"
6"
Minimum-_ Minimum --_ 6" Minimum
clearance clearance to
right
wall
to leftwall* |
/
To cabinets
below
cooktop and--_. _ 0"
at the range
back
36"
Maximum
depth for
cabinets above
countertops
i14"
(minimum)
Tocabinets below
cooktop and at the
range back
Depth with door closed (includesdoor handle)
Depth variesdepending on model.
Seespecifications sheetfor your model.
36i/j' _+l/j'
45
To Next Page
Loading...
