GEAppliances.com
Possible Causes What To Do
Excessive smoking Excessive soil. . Touch the Clear/Off pad. Open the windows to
rid the room of smoke, Wait until the LOCKEDDOOR
light goes off.Wipe up the excess soil and reset the
clean cycle.
Ovendoor will not open Oven too hot. . Allow the oven to cool below locking temperature.
after a clean cycle Do not lock the door with the door latch except when
using the self-clean feature.
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning upper oven section,
clean cycle Oven was heavily soiled. . Clean up heavy spillovers before starting the clean
cycle. Heavilysoiledovens may needto self-clean
again or for a longer period of time.
"Door" appears in the Latch handle was moved to the . Move the latch handle to the right only when setting
display (on models right but a program other than the self-cleaning cycle.
with a door latch) self-clean was selected.
"CLOSEdoor" flashes . "CLOSEdoor" reminder is always displayed at the beginning
in the display of broil cycle. Keepdoor closedwhile broiling.
"LOCKDOOR"flashes
in the display
LOCKEDDOORlight
is on whenyou want
to cook
"F--and a number or
letter" flash in the display
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
way to the right.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
. Closethe oven door and on models with a latch, move
the latch all the way to the right.
. Touch the Clear/Off pad.Allow the oven to cool
and then, on models with a door latch, unlock the door.
_ m
• The latch may have been moved, even if only slightly,
from the locked position. Makesure the latch ismoved
to the right as far as it will go.
You have a function error code.
. Touch the Clear/Off pad. Allowthe ovento cool for
one hour. Putthe oven back into operation.
Oven shelves are
difficult to slide
"Probe" appears in
the display (some models)
in the --
display
If the function code repeats. . Disconnect all power to the range for 5 minutes
and then reconnect power. Ifthe function error
code repeats,call for service.
The nickel shelves (if soequipped)
were cleaned in a self-clean cycle.
The gray porcelain-coated shelves
(if soequipped)were improperly
cleaned.
Apply a small amount ofvegetable oil to a paper
towel and wipe the edgesof the ovenshelveswith
the paper towel. Donot spray with Pam®or other
lubricant sprays.
This isreminding you to enter a
probe temperature after plugging
in the probe.
The Gas/Control Lockout feature
is activated.
. Enter a probe temperature.
. Besure the surface burner controls are turned OFF.
Turn this feature off to use the range. See the Gas/Control
Lockout section.
57
To Next Page
Loading...
