GEH-6641E
—————— Function Description ——————
100
Ch.1
· Input & ref = low lim it sets on the input and on the reference the speed lower limit
· Output = 0 it sets at zero the output state
· Output = low lim it sets on the output the speed lower limit
· Output & ref = 0 it sets at zero the output and reference state
· Output & ref = low lim it sets on the output and on the reference the speed lower limit
· Input = upp lim it sets on the input the speed upper limit
· Input & ref = upp it sets on the input and on the reference the speed upper limit
· Freeze input it freezes the input reference independently of the following variations
On the output it is possible to
monitor the output and command state.
The Block inputs are: · Motopot up src
· Motopot down src
· Motopot invers src
· Motopot preset src
The outputs: · Motopot cmd mon
· Motopot output mon
Description:
SPEED CONFIG Moto pot
Moto pot src
Mpot up src
Mpot down src
Mpot invers src
Mpot preset src
Moto pot cfg
Mpot lower lim
Mpot upper lim
Mpot acc dlt spd
Mpot acc dlt tim
Mpot dec dlt spd
Mpot dec dlt tim
Mpot init cfg
Mpot preset cfg
Moto pot mon
Mpot cmd mon
Mpot output mon
SPEED CONFIG SAVE PARAMETERS
To Next Page
Loading...
