GEH-6641E
—————— Function Description ——————
22
Ch.1
1.1.3 Signal Normalization
This paragraph describes the relationship between the physical units (rpm, Nm, A etc) and the Drive internal
values. The different values which can be read via process channels are stated through an internal value (Count
value) and the corresponding physical unit or parameter containing the reference value (Parameter name or
Physical unit value).Sometimes the paragraph makes reference to tables listed in the following pages.
The conversion type, always linear, is stated for an internal use. The code N/A (Not allowed) refers to a one to
one conversion.
IPA = Parameter number
Parameter Name Ipa Normalized
Normalized Physical
value
NULL 4000 N/A
ONE 4001 N/A
Output voltage 3060 16384
Table2 last column
Output current 3070 16384
Table1 last column
Output frequency 3080 16384
Table4 last column
DC link voltage 3100 16384
500V
Magnetizing curr 3110 16384
Table1 last column
Torque curr 3120 16384
Table1 last column
Magn curr ref 3130 16384
Table1 last column
Torque curr ref 3140 16384
Table1 last column
Current phase U 3150 16384
Table1 last column
Current phase V 3160 16384
Table1 last column
Current phase W 3170 16384
Table1 last column
Flux ref 3180 16384
1Wb
Flux 3190 16384
1Wb
Ramp ref 3200 16384
Full scale speed
Speed ref 3210 16384
Full scale speed
Speed 3220 16384
Table3 last column
Norm Speed 3221 16384
Full scale speed
Fault Pin 9098 N/A
Norm Std enc spd 3222 16384
Full scale speed
Norm Exp enc spd 3223 16384
Full scale speed
Drv OL accum % 1540 16384
100%
Mot OL accum % 1670 16384
100%
BU OL accum % 1781 16384
100%
Drive ready 161 N/A
Enable SM mon 162 N/A
Start SM mon 163 N/A
FastStop SM mon 164 N/A
ALM Sequencer 9096 N/A
Drive OK 9097 N/A
Jog state 8013 N/A
Gen output 2760 N/A
An inp 1 output 5009 16384
10V or 20mA
An inp 2 output 5029 16384
10V or 20mA
An inp 3 output 5049 16384
10V or 20mA
An inp 1X output 5067 16384
10V or 20mA
An inp 2X output 5087 16384
10V or 20mA
TAVyS00a
To Next Page
Loading...
