GE Concord Ultra - Commands at a Glance; System Arming and Disarming Commands; Alarm and Sensor Control Commands; System Status and Feature Control Commands

Commands at a Glance
Disarm the system.
Cancel an accidental alarm.
1 + CODE
Arm to Level 2—STAY.* 2 + CODE
Arm to Level 3—AWAY.* 3 + CODE
Send a police alarm. Press and hold both POLICE buttons for
2 seconds.
Send an auxiliary alarm. Press and hold both AUXILIARY
buttons for 2 seconds.
Send a fire alarm. Press and hold both FIRE buttons for 2
seconds.
Arm system with No Delay.*
2 + CODE + 4 or
3 + CODE + 4
Arm system for Latchkey.* 2 + CODE + 6 or
3 + CODE + 6
Bypass a sensor.* Indirectly: 2 + CODE + # or
3 + CODE + #
Directly: # + CODE + Sensor Number
Arm system silently.*
5 + 2 + CODE or
5 + 3 + CODE
Arm system with exit lights
off.*
2 + CODE + 0 or
3 + CODE + 0
Turn all lights on/off. 0 + 0
Turn specific lights on/off. 0 + Light number
Check the system status. * for Short status or * + * for Full status
Turn Chime on/off. 7 + 1
Turn Energy Saver on/off. 7 + 2
Disable local phone access.**
(This is a phone command
only.)
# + 7 + 3
or wait 5 seconds after picking up the phone
Check alarm memory.
7 + 6
Activate Output.*** 7 + 7 + Output number (1–6)
View Event History
8 + CODE + 8
*If Quick Arm feature is on, access code is not required. See “Arming Your System”.
**Installer can disable local phone control if desired.
***Must be set up by installer.