– 13 –
(Continued Next Page)
The GE dryer is designed to allow placement
(stacking) on top of certain GE front load washers.
Washer models that currently qualify are:
WCVH4800K•
WCVH4815K•
Note: If you are planning to stack the washer and
dryer, order Stacking Kit number GE24STACK to be
used for this dryer. Kit sold separately.
IMPORTANT –• Save these instructions for local
electrical inspector’s use.
IMPORTANT –• Observe all governing codes and
ordinances.
Note to Installer –• Be sure to leave these
instructions with the Consumer.
Stacking installations may require a power cord •
up to six feet in length.
WARNING!
• Make sure the dryer is unplugged.
• More than 2 people are recommended to safely
lift the dryer into position.
• Avoid damage to the existing utility services.
DO NOT• place the washer on top of the dryer.
Location Requirements
When installed in a location other than an alcove
or closet, the minimal clearances to combustible
surfaces and for air opening are: 0 inches on both
sides, and 3 inches front and rear. Consideration
must be given to provide adequate clearance for
installation and service.
Note: If your dryer is approved for installation in an
alcove or a closet, it will be stated on a label on the
back.
When installed in an alcove or closet:
The dryer MUST be vented to the outdoors. •
Minimum clearance between dryer cabinet •
and adjacent walls or other surfaces is 0 inches
either side, and 3 inches front and rear.
Minimum vertical space from fl oor to overhead •
shelves, cabinets, ceilings, etc., is 67.7 inches.
Closet doors must be louvered or otherwise •
ventilated and have at least 60 square inches
of open area equally distributed. If the closet
contains both a washer and a dryer, doors must
contain a minimum of 120 square inches of
open area equally distributed.
Note: WHEN THE EXHAUST DUCT IS LOCATED AT THE
REAR OF THE DRYER, MINIMUM CLEARANCE FROM
THE WALL IS 5.5 INCHES.
Stacking Instructions
To Next Page
Loading...
Need help?
General
