2-6 DINAMAP
®
ProCare Monitor Service Manual Revision C
2009381-001
Equipment Overview: Basic Components
20. Inflate pressure: lights to indicate you are making a change to the inflation
pressure.
21. Pulse Rate window: 3-digit yellow LED shows pulse rate in beats per minute.
22. SpO
2
pulse indicator: Red LED bar flashes to indicate that real-time pulse
rate measurements are being derived from SpO
2
signals.
23. SpO
2
window: 3-digit red LED indicates oxygen saturation in %.
24. MAP/Cuff window: 3-digit red LED indicates measured MAP in mmHg and
shows instantaneous cuff pressure during BP determination.
25. Min window: Displays the BP mode if manual or STAT is the cycle time when
in Auto Cycle mode.
26. Battery power indicator: Green LED indicates the Monitor is operating on
battery power.
27. Low battery power indicator: Yellow LED indicates LOW charge status of
internal battery.
28. Charging indicator: Green LED indicates presence of external power source
and battery charging.
29. Temperature window: 4-digit red LED indicates measured temperature.
To Next Page
Loading...
